Set a byte value to the controller, see the datasheet for usage. They needed deleting and replacing for some reason It kind of flickers when the program stats, and ends and there is some flickering in the middle but no matter how hard I try I cann’t see anything displayed. Please post a your working sample if its no problem. To use the KS driver simply include the following in your user code. If anyone rectified this errors help me..
|Date Added:||8 July 2010|
|File Size:||64.9 Mb|
|Operating Systems:||Windows NT/2000/XP/2003/2003/7/8/10 MacOS 10/X|
|Price:||Free* [*Free Regsitration Required]|
This equates to the 8 pixel high. GPIO number Assignment self. Optional, but recommend NOT to set.
Looking for C18 or XC8 GLCD 240×128 library (ks0108 or t6963)
CS2, 0 def useDisp2 self: I copied your code into geany and then messed around for about an hour because it was complaining about indents. Draw a box on the GLCD to a specific size that is filled with the foreground colour. Any suggestions would be appreciated.
While i use remote login putty software to run my program it works well. Board index All times are UTC.
KS – Cookbook | Mbed
For a KS datasheet, please refer here. Hi friends,i had try to run the clock. Set a byte value to the controller, see the datasheet for usage. Please post a your working sample if its no problem. This equates to the standard GCB font set. kz0108
If anyone rectified this errors help me. Linkx only connectivity option is the 8-bit mode where 8 connections for the data are required between the microcontroller and the GLCD to control the data bus. I for example have also sutch a screen and would like to try this on the raspberry. To use the KS driver simply include the following in your user code.
It almost done but I have problem on write operation’s timing control. My first thought was a poor connection as I’m using a breadboard but I lunux now doubled up on all of the connections so I am sure each pin has a good contact. So it works like Display Off command. If do it, display off the pixels, but after the command ‘Display ON’ is sent, the written before data will be displayed again.
Defining this will invert the Y Axis. I had to add in “self” into the def useDisp1 and useDisp2 defs ass it was giving the error: Set a pixel on the GLCD at a specific position that is set with the specific attribute. I have a 5k pot on pin 3 and pin 18 and despite trying every combination of each pot high and low The RAM content is not cleared.
display: Driver ks and cfagb 
Read a byte value from the controller, see the datasheet for usage. So, if i’m right, kks0108 only one way to clear display RAM is write 0x00 to all dots? Please can you help Thank you.
In the code I have swapped the linkx numbers to match how I have wired my screen, and when I run the program I get no errors in the LX Terminal Does anybody know how to manage hardware reset for display? It kind of flickers when the program stats, and ends and there is some flickering in the middle but no matter how hard I try I cann’t see anything displayed.
Draw a box on the Oinux to a specific size.
Default is 9 Can be set to improve overall performance. I feel like I must be missing something, has anyone got any ideas?